Corner key is the name of the space bar material. Plastic injection machine special for raw-material cooled under pressure in the mold is produced by pressing. Keys are not subject to corrosion, does not rust, be flexible and not break the special plastic material used in manufacturing. Even the glass used in manufacturing aluminum space bar profiles between the glass has been cut to measure profile rectangular frame into a key for the corner with this, the moisture inside the receiver is filled then are added to each other. Then between two glass will be closed by putting butyl and Thiokol. Keys entered into between the lath profile sectional view of the profile and extent of internal cross-section is the same as the internal dimensions of the profile is the same extent. Profile quotes contact you on the clip that allows you to make, so that you corner key out and the moisture profile back from the receiver to prevent leakage to the outside. You have a hole in the corner clip and when done to close this hole is also a plug.

             TECHNICAL SPECIFICATIONS:              
The holes are located on the clip transport, transportation, such as cases where the atmospheric pressure change between the two glass formation due to pressure difference between atmospheric pressure prevents the explosion of glass. If you do not hole on the clip pressure in the external environment is changed, the pressure will remain constant pressure difference between two glass are broken for this. Even during the installation of glass in the two outside receivers moisture between the glass to reduce the permeability of UV rays and to ensure greater transparency of glass with argon gas is put in it. When the argon gas put in it the clip's hole closed with its plug. Argon gas to prevent leakage to the outside. When the clips used in space bar, you may not use silicon or needling the space bar.

Corner key width is 0.5 mm. It is smaller than spacer bar profile.ıt ıs perfectly enter the spacer bar.

Technical Dimensions   Width Pack Quantity: Pieces of 7.6        10.000     9.6        10.000     10.6        10.000     13.6        5.000     14.6        5.000     22.6        5.000

Production of clips are package as 10,000 units.They are sell like this.